Helloooo !
Just repolaced the waste pipe thing on the kitchen sink as I managed to break the old one off - oops ! Are there special tools to tighten up those collars on the plastic pipes - hand tight doesn't seem to be doing the job ?
Also - hot tap on the downstairs sink is just coming out very very slowly. Hot water upstairs is fine ? Anyone any ideas ?
Worth a go anyway ! Ta !
0 ·
Comments
Shoulda been a plumber ! Maybe I should sue the careers teacher. Actually I cant remember a single thing he told us. Hmmmm.
Any plumbers turned up yet ?
So whasssup BB ? Like the pic - is this you or a pic de plume ?
So what exciting news have you ? I've been good for the past 2 days, and not posted from work. Hard but had to be done. I see I missed a lot ! Mainly smut. Damn !
admire your restraint i'm addicted
lots of smut
I had to stop - or else I'm sure I'd end up sacked - it is tooooo addictive.
Pah - wheres the night time smut. Oh, Wolfy only posts in the daytime ! ;-)
1. Yes, you can buy special tools for a few quid. Can't remember what they're called but if you pop into B & Q and go to the plumbing part you'll probably see the tools that have big enough jaws to grip.
2. Sounds like an air block. If you get a bit of hosepipe and connect the cold water tap to the hot water tap and turn them both on the cold water goes into the hot water pipe and removes the air block. Can be a bit messy so get lots of towels out! There are another few reasons but this is the one I've had most often.
Hope that helps!
1. Thanks - will do that.
2. Blimey - that sounds clever - will give that a go ! Cheers !
I knew it was worth a post.
Happy Bikng & Running !
I'm not a plumber so no warranties offered!